Euro/horn turn-signal switch conversion to our turn-signal switch with cruise:

[itking]

Here's some pictures & comment of what I did. I have it currently working perfectly in Raven.

[itking]

First it took apart the broken switch with cruise cause I needed the pin with the tab.

Note. You will have to drill out the rivits carefully.There are 2 other pins that each have tabs which can be used to make the same pin/tab combo. So 1 broken cruise switch can be used to modify 3 euro's.

[itking]

You will have to remove the wire with a solder gun. Carefully use a Dremel to cut the bent metal piece out of the way in the channel the wire will follow up to & to also make a indentation so the tab will be flush with the plastic.

[itking]

The solder wire to tab, carefully press pin in place while guiding the wire in the channel.